ION Brisa Instructions De Montage Et Utilisation page 9

Bring the main post (B) up to boss on
the main body (A), Fig. 7.
Take the tip of the tension cable (62),
sticking out of the bottom of the main
post (B) and connect it to the tension
support (61), as shown in Fig. 7A.
Plug connector (53), coming out of the
main post, into connector (84), coming
out of the boss on the main body (A),
Fig. 7A.
Slip the main post (B) over the boss (A)
on the main body in the direction of the
arrow, Fig. 7, making sure not to snag
any of the cables.
ATTENTION: Make sure that the
tension control (62) functions correctly
by turning
counterclockwise.
Fit the screws (16), along with the
washers (17)
previously, Fig.7, and tighten securely.
Fit front screws (48) with the grower
washer (17), the corrugated washers
(49), fit the washer (15) and the nut
(59) on the other end of the screw and
tighten securely.
Lower the bottom trim section for the
main post (B) down over the boss
section of the main body (A), Fig. 8.
6. ATTACHING THE FEET
Take the left foot (30), insert the bottom
focus bar spindle (21), Fig. 8, position
it at the bottom of the left focus bar
(18), Fig. 8, insert screw (22) and fit the
flat washer (23) and the self locking nut
(19) and tighten securely.
Take the right foot (96), insert the
bottom focus bar spindle (21), position
it at the bottom of the right focus bar
(94), insert screw (94) and fit the screw
(22), the flat washer (23) and the self
locking nut (19) and tighten securely.
it clockwise
and (49), removed
7. ATTACHING THE
FOOTREST COVERS WITH
KNUCKLE JOINTS
Next fit the footrest covers (24 & 29)
with the bottom of the joints on the left
side, Fig.8. Use screws (25) to screw
them together.
Then do the same with the other
covers (24 & 29) on the right-hand
side.
8. ATTACHING THE UPPER
FOCUS BARS
Take the top left bar (5) (marked with
the letter "L"), connect the terminal (8)
coming out of the bottom of the bar
and with the terminal (55) coming out of the
bottom bar. Fig.9.
Insert the top bar onto the bottom left
focus bar (18), lining up the letters (L),
Fig.9, fit the screws (7), the curved
washers (9) and the cap nuts (10) and
tighten securely. Now go through the
same procedure for the top right focus
bar (92).
9. ATTACHING THE
ELECTRONIC MONITOR
ATTACHING THE FEEDBACK CABLE.
Take hold of the cable (53), which is
sticking up out of the main post (B),
Fig. 10, and plug it into the connector
(53a) at the back of the electronic unit
(43), as shown in Fig. 10
CONNECTING
CABLE Take hold of the Hand-grip
connectors (54 & 55), sticking out of
the main post (B), and plug them into
the connectors (54a & 55a) located at
the back of the monitor (43), as shown
in Fig. 10.
8
THE HAND-GRIP