necessary, use only a soft brush to clean it carefully and gently. DO NOT apply any
pressure to the net.
5. To lock the lid onto the filter cone, align the slot of the lid's edge to the tab of the
bottom part of the cone. Push the lid on the cone and turn the lid anticlockwise until it
stops. Attach the filter cone to the transparent case.
CAUTION! Replace a damaged filter cone immediately with a new one before the next
operation.
6. To re-position the transparent canister (with filter cone inside) onto the rear body,
make sure the locking knob on each side is turned to the unlocked position. Align the
raised arches on both sides of the transparent canister with the locking knobs and
turn each knob clockwise until it points towards the red marking to secure the
assembly.
Attention: The case has one correct position only. The water-draining valve
must be facing the bottom when holding the cleaner horizontally by the handle.
MAINTENANCE & STORAGE
NOTE:
1. Battery discharges on its own during storage. Make sure to fully-charge the pool
vacuum before storage.
2. You must re-charge the battery at least once every three months when it is not in
use.
Unplug the external adaptor from the socket and then unplug the adapter jack from
the charging base.
Detach accessories from the pool vacuum. If necessary, rinse the pool vacuum and
accessories with fresh water. DO NOT use detergent.
13