Operation - Interline EV50 Manuel D'emploi

To release the telescopic pole, press down on the two side pins simultaneously and
pull out the pole.

OPERATION

WARNING!
Do not use the pool vacuum if any damage is detected.
Oil stain could occur due to possible leakage of lubricants applied to the O-ring.
Do not operate this pool vacuum if there are people/pets present in the water.
Make sure the pool vacuum is fully immersed in the water before initiating operation.
The minimum water level required to operate the device must reach above the
power button of the pool vacuum when it is held in a vertical position. Operating the
pool vacuum when not immersed in the water correctly can damage the unit and
the warranty will be voided as a result.
Maximum operating depth in water is 3 meters (10 ft).
Maximum water temperature: 5˚C (41˚F) –35˚C (95˚F)
DO NOT use the pool vacuum without an intact filter cone in place. Using your pool
vacuum without an intact filter cone in place will VOID your warranty.
Suction entrapment hazard: This pool vacuum generates suction. Do not allow hair,
body or any loose parts of your clothing to make contact with the suction mouth of
the pool vacuum during its operation.
Never insert body parts, clothing or other objects into the openings and moving
parts.
DO NOT use this pool vacuum to pick up any toxic substance, flammable or
combustible liquids such as gasoline, or operate in the presence of explosive or
flammable fumes.
DO NOT cover the side slot of the cleaner body during operation. The
impeller/motor may be damaged as a result.
Never insert any object to touch the impeller.
CAUTION
Use only original accessories delivered with this product.
DO NOT use this pool vacuum immediately after pool-shocking. It is recommended
to leave the pool circulating for at least 24-48 hours.
It is not recommended to use this pool vacuum with another pool vacuum/cleaner
simultaneously.
DO NOT leave the pool vacuum in the water when it is not in use or when battery is
low as water leakage may occur.
1) Bring your pool vacuum to the side of your pool / spa. Immerse the pool vacuum in
water and press the power button to initiate operation.
11