Electrical Powering; Rs485 Interface For Connection To Enod4 - Scaime eNodTouch-MS Guide Rapide

•
Confirm that the installation gasket is attached to eNodTouch unit and then place the unit into the Panel from the front.
•
It is strongly recommended that you use the installation gasket, since it absorbs vibration in addition to repelling water.
•
Press the installation fastener hooks securely into the insertion slots on eNodTouch.
•
Tighten the installation fasteners with a screwdriver. There are two insertion slots on both the top and bottom.
NOTE: When installing to panel cut-out for monochrome model (eNodTouch-S) the eNodTouch-S Panel Cut-out Adapter (ref.
632156) is required. In this case, before placing eNodTouch-MS into the Panel:
- Remove the gasket from this product
- Attach the eNodTouch-S Panel Cut-out Adapter to this product:

Electrical powering

•
Supplying a power voltage other than that specified will damage the power source and the unit.
•
When the FG terminal is connected, be sure the wire is grounded.

RS485 interface for connection to eNod4

•
The serial interface is not isolated. Always connect the SG (Signal Ground) of the unit to the connected device.
•
SG (Signal Ground) and FG (Frame Ground) are connected internally
•
Conductor type
Quick Start Guide SCAIME:
1- eNodTouch-S Panel Cut-out Adapter
+
-
Grounding Terminal
FG
to eNodTouch chassis
Simple Wire: 0.75 to 1.5mm2
Stranded Wire: 0.75 to 1mm2
10
NUSG-eNodTouch-MS-FE_196776_D.docx
24V
0V
connected