Manufacturer's Warranty; Notice D'utilisation Originale; Indications Relatives À La Documentation - Hilti SIW 22T-A Mode D'emploi

Trouble or fault
The control switch cannot be
pressed.
Speed of rotation drops con-
siderably.
The battery is not heard to
engage.
The battery runs low more
quickly than usual.
The tool or the battery gets
very hot.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10 RoHS (Restriction of Hazardous Substances)
The following links take you to the table of dangerous substances: qr.hilti.com/r4265 (SIW 22T-A 1/2") and
qr.hilti.com/r2922676 (SIW 22T-A 3/4").
You will find a link to the RoHS table, in the form of a QR code, at the end of this document.
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.

Notice d'utilisation originale

1 Indications relatives à la documentation
1.1 À propos de cette documentation
• Lire intégralement la présente documentation avant la mise en service. C'est la condition préalablement
requise pour assurer la sécurité du travail et un maniement sans perturbations.
• Bien respecter les consignes de sécurité et les avertissements de la présente documentation ainsi que
celles figurant sur le produit.
• Toujours conserver le mode d'emploi à proximité du produit et uniquement le transmettre à des tiers
avec ce mode d'emploi.
10 Français
Possible cause
The forward / reverse selector
switch is in the middle position.
Low battery.
The retaining lugs on the battery
are dirty.
Very low ambient temperature.
The tool is overloaded (application
limits exceeded).
Action to be taken
▶ Set the forward / reverse
selector switch to forward or
reverse rotation. → page 7
▶ Charge the battery. → page 7
▶ Clean the retaining lugs.
▶ Warm up the battery slowly to
room temperature.
▶ Select a product that is suitable
for the intended purpose.
409099
*409099*