Disposal; Manufacturer's Warranty - Tools - Hilti SF 22-A Mode D'emploi

Fault
The battery runs down more
quickly than usual.
The battery doesn't engage with
an audible double click.
The power tool or the battery
gets very hot.

9 Disposal

CAUTION
Improper disposal of the equipment may have serious consequences: the burning of plastic components generates
toxic fumes which may present a health hazard. Batteries may explode if damaged or exposed to very high
temperatures, causing poisoning, burns, acid burns or environmental pollution. Careless disposal may permit
unauthorized and improper use of the equipment. This may result in serious personal injury, injury to third parties and
pollution of the environment.
CAUTION
Dispose of defective batteries right away. Keep them out of reach of children. Do not disassemble or incinerate the
batteries.
CAUTION
Batteries that have reached the end of their life must be disposed of in accordance with national regulations or returned
to Hilti.
Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back your old power tools or appliances for recycling. Please ask your Hilti customer service department or
Hilti representative for further information.
For EC countries only
Disposal of electric tools together with household waste is not permissible.
In observance of the European Directive on waste electrical and electronic equipment and its imple-
mentation in accordance with national law, electrical appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.

10 Manufacturer's warranty - tools

Please contact your local Hilti representative if you have
questions about the warranty conditions.
Possible cause
Very low ambient temperature.
The retaining lugs on the battery are
dirty.
Electrical fault.
The power tool has been overloaded
(application limits exceeded).
Remedy
Allow the battery to warm up slowly
to room temperature.
Clean the retaining lugs and push the
battery in until it engages. Contact
Hilti Service if the problem persists.
Switch the tool off immediately, re-
move the battery and contact Hilti
Service.
Use the right power tool for the job
(don't use a low-powered tool for
heavy work).
en
19