Functional Description - Black & Decker MM2000 Mode D'emploi

conditions that may affect their
operation. A guard or other part that is
damaged should be properly repaired
or replaced by an authorized service
center unless otherwise indicated
elsewhere in this manual.
• RepAIRS ANd SeRVIce. Repairs,
maintenance and any adjustments
not specified in this manual should
be performed by blAcK+decKeR
authorized service centers or other
qualified service organizations, always
using identical replacement parts.
WARNING:
this product contains chemicals known to
the State of california to cause cancer,
birth defects or other reproductive harm.
Some examples of these chemicals are:
• compounds in fertilizers
• compounds in insecticides, herbicides and
pesticides
• arsenic and chromium from chemically
treated lumber
To reduce your exposure to these chemi-
cals, wear approved safety equipment
such as dust masks that are specially
designed to filter out
microscopic particles.

FUNCTIONAL DESCRIPTION

1. Switch box
2. bail handle
3. Upper-handle
4. lower-handle
5. Upper-handle attachment levers (2)
6. lower-handle attachment levers (2)
7. cut height adjust lever
8. grass collection bag
9. Rear door cover
10. carrying handles
11. edgemax™
ASSEMBLy
WARNING:
before assembly, make
sure the bail handle is released and the
mower is unplugged.
ATTAChING LOWER hANDLE
• lift lower handle (4) into place making
sure the arrow (15) on the base of the
mower lines up with 1, 2, or 3 on the base
of the handle (16) (inset of Figure C)
Some dust created by
10
• The label on your tool may include the
following symbols. The symbols and their
definitions are as follows:
V ..................volts
mW..............milliwatts
nm ...............wavelength in nonometers
A ..................amperes
hz ................hertz
W .................watts
min ..............minutes
or Ac ......alternating current
or dc ...direct current
n o ................no load speed
................class i construction
................earthing terminal
...............safety alert symbol
................class ii construction
.../min or rpm...revolutions or
................. Use proper respiratory protection
................. Read instruction manual before use
................Use proper eye protection
...................Use proper hearing protection
5
9
10
cAutIoN:
lower handle is set on the same number.
The arrow must be lined up with 1, 2, or 3
for operation.
• Close the handle height adjust levers
(6) as shown in Figure C. As you close
each, make sure the teeth are engaged
as shown in Figure D.
• if the connection between the handle
and lever is too tight or loose, open the
6
(grounded)
(double insulated)
reciprocation per minute
1
8
11
ensure each side of the
2
3
4
6
7