Setting Up Your Refrigerator; Getting Ready To Install The Refrigerator - Samsung RF32FMQDBSR Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

setting up your refrigerator

GETTING READY TO INSTALL THE
REFRIGERATOR
Congratulations on your purchase of the Samsung
refrigerator. We hope you enjoy the state-of-art
features and efficiencies that this new appliance
offers.
Selecting the best location for the
Refrigerator
Choose :
• A location with easy access to the water supply.
• A location without direct exposure to sunlight.
• A location with level (or nearly level) flooring.
• A location with enough space for the refrigerator
doors to open easily.
• A location that allows sufficient space to the
right, left, back, and top for air circulation. If the
refrigerator does not have enough space, the
internal cooling system may not work properly.
• A location that allows you to move the
refrigerator easily if it needs maintenance or
service.
• Do not install the refrigerator in locations where
the temperature is over 109 °F (43 °C) or below
41 °F (5 °C ).
A
A
E
E
C
C
Depth "A"
Width "B"
Height "C"
Overall Height "D"
DA68-02918A-05.indb 9
B
B
D
D
35 ¾" (908 mm)
35 ¾" (908 mm)
71 ¾" (1822 mm)
72
/
" (1850 mm)
7
8
2"
(50 mm)
125°
59 6/8" (1519 mm)
35 3/4" (908 mm)
2 6/8" (72.3 mm)
1 3/4" (43 mm)
Each measurement based on the design
dimension, so it may differ depending on the
measuring method.
When moving your refrigerator
To prevent floor damage, be sure the front leveling
legs are in the up position (above the floor).
Refer to "HOW TO LEVEL THE REFRIGERATOR"
in the manual on page 13.
FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the same
height as the rest of the floor.
This surface should be strong enough to support a
fully loaded refrigerator.
To protect the finish of the flooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working.
When moving the refrigerator, you need to pull and
push it straight forwards or back. Do not wiggle it
from side to side.
125°
12"
(305.5 mm)
setting up _09
14. 6. 25.
10:57

Publicité

Table des Matières
loading

Table des Matières