Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN Safety
PL Bezpieczeństwo
• Do not allow aluminium foil, plastic, paper or fabric
contact with heating elements. Never leave the
appliance unattended during use, especially when
cooking with flammable substances (e.g. hot oil, fat, etc.).
• Do not store or never use harsh chemicals, sprays,
flammable or non-food in or near the oven. This oven
is designed specifically for heating or cooking food.
The use of corrosive chemicals in heating or cleaning
will damage the unit and may cause injury.
• Should any food inside the oven catch fire, keep the
door closed. Switch the oven off and disconnect
the power supply. Always exercise caution when
opening the door.
• Move to the side, and open the door slowly to vent the
hot air and/or steam. Make sure your face is away from
the opening and make sure there are no children or
pets near the oven.
• Only use utensils that are suitable for use in this
type of oven.
• Do not use any silicone pans, or any mats, covers or
accessories that contain silicone. The silicone may
melt and damage the surface of the product.
• The oven should be cleaned regularly and any food
deposits removed.
• Do not use harsh abrasive cleaners or sharp metal
scrapers to clean the oven door glass. They can
scratch the surface, which may result in shattering
of the glass.
• A steam cleaner is not to be used.
WARNING: The appliance and its accessible parts
become hot during use. Care should be taken to avoid
touching heating elements.
• Children less than 8 years of age shall be kept away
unless continuously supervised.
• The appliance must not be installed behind a
decorative door in order to avoid overheating.
EN
Installation
All installation must be carried out by a competent
person or qualified electrician. Before connecting the
mains supply ensure that the mains voltage corresponds
to the voltage on the rating plate.
Direct Connection
• The appliance must be connected directly to the
mains using an omnipolar circuit breaker with a
minimum opening of 3 mm between the contacts.
FR Sécurité
RO Siguranță
• The installer must ensure that the correct electrical
connection has been made and that it complies with
the wiring diagram.
• The cable must not be bent or compressed.
• Regularly check the power cord for damage. If the
supply cord becomes damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
• WARNING: This is a Class I appliance and MUST be earthed.
• The appliance is supplied with a 3-core mains cable
and must be connected to the electricity supply via a
double pole switch having a 3 mm minimum contact
gap on each connector.
• The Residual Current Device (RCD) must be rated at
16 Amps.
The wires in the mains lead are coloured in accordance
with the following code:
Brown = L - Live
Blue = N - Neutral
Green and Yellow =
- Earth
EUR
N
N
L
L
(Blue)
N
L
(Brown)
(Green/Yellow)
To avoid the risks that are always present when you
use an electrical appliance it is important that this
appliance is installed correctly and that you read the
safety instructions carefully to avoid misuse and hazards.
Please keep this instruction booklet for future reference
and pass it on to any future owners. After unpacking the
appliance please check that it is not damaged. If in doubt,
do not use the appliance but contact Customer Services
- see end of Care & Maintenance section for details.
03
UK
DOUBLE POLE SWITCHED
FUSED SPUR OUTLET
FUSE ON
USE A 16AMP FUSE
Publicité
Table des Matières
