Kemper PROFILER PowerHead Guide Rapide page 18

18 PROFILER QUICKSTART
Use the <PAGE> buttons to navigate to the "Output Sources" page
and then activate "Monitor Cab Off" with the corresponding soft
button above the display.
Use the MASTER VOLUME knob on the front panel to control your
volume.
If you're on stage, or in a studio, you won't require a microphone to
pick up your sound, so you should connect the mixing desk to the
MAIN OUTPUTS XLR outs.
In such a scenario, you should unlink the Main Output Volume from
Master Volume, so that you are able to control your Monitor
Volume independently from the level sent to the mixing desk.
At this point, we should mention that the internal power amp is
fed by the same signal that is sent to the MONITOR OUTPUT on
the rear side. Any settings that affect the MONITOR OUTPUT, e.g.
Monitor Output Volume, affect the guitar cabinet as well.
TYPE
STORE
Main Out -12 dB Monitor Cab O
OUTPUT Section [Page 1/6]
UNDO REDO Output Source
Master Stereo Master Mono
Main Output Monitor Output
N
LEFT RIGHT
K USB
TYPE
STORE
Main Out Link Monitor Out Link
OUTPUT Section [Page 2/6]
Output Volumes
UNDO REDO
-12.0dB -12.0dB
Main Volume Monitor Volume
N
BROWSE
EXIT
Monitor Stereo
PAGE
Git+Processing Master Stereo
Direct Output SPDIF Output
MAIN OUTPUT
LEFT RIGHT
GROUND
LIFT
POWER
BROWSE
EXIT
Direct Out Link Headphone Link
PAGE
-12.0db -12.0db
Direct Volume Headphone Vol.
VO
VO