Connecting The Receiver - Marmitek URROUND ANYWHERE 220 Guide Utilisateur

3. Connecting the receiver

Connect the DC power input of the receiver with the supplied large
AC adapter. The use of a surge protector is recommended to protect
the receiver from power surges which may damage the receiver and
connected speakers or may cause audio dropouts.
The receiver connects to regular passive loudspeakers via regular
speaker cables (not included). Observe the correct polarity when
connecting the speakers.
It is also possible to connect both speakers to separate receivers by
using an additional receiver. In this case connect one speaker to the
left audio output of the first receiver and the second speaker to the
right audio output of the second receiver. One audio output of each
receiver will not be used in this case.
1
ATTENTION!
Never short circuit any receiver audio output since this may damage
the receiver. A clicking noise may be generated during receiver power
up. Therefore, it is recommended to connect power to the receiver
prior to connecting the speakers.
4
receiver
SPEAKER OUTPUTS
L R
Speakers
DC 24V
AC adapter
DC 24 V DC 24 V
1000 mA 1000 mA
Power outlet
© MARMITEK