Surround Anywhere 220; Connecting The Transmitter - Marmitek URROUND ANYWHERE 220 Guide Utilisateur

Unpacking
Check that this package contains:
x
One 5.8 GHz Digital Audio transmitter
x
One Digital Audio receiver
x
One small and one large AC adapter
x
Two short speaker cables
x
This userguide

1. Surround Anywhere 220

Congratulations with the purchase of the Marmitek Surround
Anywhere 220!
With this you can easily connect your rear surround speakers
wirelessly to your Home Cinema set. Because of the built-in amplifier
in the receiver you can use your present (passive) surround speakers.
The uncompressed digital transfer ensures a sound which goes
beyond CD-quality, without interference or delay. Because the sound
is controlled through your Home Cinema set and the automatic on/off
function of the transmitter and the receiver, it needs no looking
after.
Marmitek-products are manufactured with utmost precision and are
of high quality.
Please read this operating instructions and follow the directions so
you can enjoy the possibilities of this product optimally.

2. Connecting the transmitter

The transmitter connects to an amplified speaker output via the
supplied short speaker cables. Alternatively it can be connected to a
standard line-out audio interface.
If the transmitter is connected via speaker cables, observe the polarity
of the cable connection to ensure that the transmitter will be fed
with a correct polarity signal. If one of the cables is switched
(reversed), one speaker will receive an opposite polarity signal which
will degrade sound performance.
2 © MARMITEK