Publicité
Les langues disponibles
Les langues disponibles
User Manual
RAID mode setting:
Warning: Save or back up any important data before you proceed. Setting or changing your RAID
configuration will erase the data or metadata on your existing drives. To backup data please use the PM
mode before switching to RAID mode otherwise your data will be permanently lost.
1. Set the RAID switch (SW4) to either OFF or ON, depending on the desired configuration.
2. Connect the enclosure to your USB host device. Refer to the documentation that came with your
USB host device for more information about how to connect your enclosure.
3. Press the Reset Button (SW1) on the enclosure for 1 or 2 seconds.
LED indicators:
•
LED is flashing white: indicates drive activity
•
LED is flashing red: indicates the drive is disconnected or defective
•
Both LEDs are flashing white: indicates a RAID array is in the process of being rebuilt; LEDs will
turn off when the rebuild process is complete
English
Publicité
