Placing The Receiver; Wireless Control - Trust START-LINE ACM-2300H Guide Rapide

ACM 2300H BUILT IN SWITCH
EN

9. Placing the receiver

Place the receiver in the ceiling box. Mount the lights back in place or use a cover.
Make sure that you can always reach the receiver, for example, to reset it, or to register a new
transmitter.
Make sure no stripped parts of wires touch each other.

10. Wireless control

Send with the transmitter an ON signal to turn the light on wirelessly.
Send with the transmitter an OFF signal to turn the light o wirelessly.
Consult the manual of the transmitter for more information.
The existing wall switches which are used to control the connected lighting can still be used.
Deleting a single transmitter code
(a) Press for about 1 second on the Connect button. The 'pairing mode' will be active for 15 seconds
and the LED indicator on the receiver will fl ash slowly.
(b) Send while the 'pairing mode' is active with the connected Trust Smart Home transmitter an
OFF signal. If necessary, consult the instruction manual of the transmitter.
(c) The LED on the module will fl ash 2x to confi rm that the code has been removed.
Repeat this procedure to delete several transmitters from the receiver.
Erase entire memory
(a) Press the Connect button for about 8 seconds until the LED indicator fl ashes quickly.
(b) When the LED indicator fl ashes rapidly, press the Connect button again for 1 second to confi rm that
you want to completely erase the memory.
(c) The LED on the module fl ashes 2x to confi rm that the memory has been erased.
3