Trust START-LINE ACM-2300H Guide Rapide page 10

ACM 2300H BUILT IN SWITCH
EN
(d) Connect two new live wires from the live wire terminal block to the [L] and [COM] contact.
(e) Tighten the terminal screws of the ACM-2300H.
This is the technical installation schematic of the ACM-2300H with two wall-switches (hotel/stairwell
circuit).
This is the technical installation schematic of the ACM-2300H with one wall-switch.
7. Enable mains power
Switch the mains power ON before proceeding with the installation.
Make sure no stripped parts of wires are touched after this step.
The LED indicator on the receiver will be lit for a few seconds when voltage is applied.
8.1 Activate pairing mode
Press for about 1 second (with a pointed object) on the Connect button to activate the pairing mode.
The pairing mode will be active for 15 seconds and the LED indicator on the receiver will fl ash slowly.
8.2 Send an ON signal
While the LED indicator fl ashes, press the ON button on a Trust Smart Home transmitter to pair the
transmitter to the ACM-2300H. (Or activate a Trust Smart Home sensor).
8.3 Pairing confi rmation
The LED on the module will blink 2x in order to confi rm that the code is stored. The receiver can store
up to 6 di erent transmitter codes in its memory per channel. The memory is retained when the
receiver is installed elsewhere or when there is a power failure.
2