Getting Started; Charging The Battery; Reading Led Indicators; Inserting A Memory Card - AIPTEK PocketCinema V50 Guide Utilisateur

User's Manual

Getting Started

Charging the battery

The internal battery of the device may not be fully charged when
you use the projector for the first time. You can charge the battery
in the following two ways:
Plug the AC power adapter into the DC-IN jack of the device,
●
and connect the other end to the power source.
Connect the small end of the supplied USB cable to the USB
●
port of the device, and the large end to a powered PC. Make
sure the projector is powered off.
Power OFF, charging by AC power adapter
Power OFF, charging by USB connection
Power ON and connect AC power adapter
Power ON and connected with USB cable

Reading LED Indicators

During charging, the LED on the device indicates the level of the internal battery:
Orange - battery charging
●
Green - battery full
●
When using a PC to charge the battery, always turn off the projector. Otherwise, the
charge will stop.

Inserting a Memory Card

Open the cover of the SD Card Slot. Close the cover of the slot.
Hold the SD card by the edges and gently insert it into the slot (as
shown below) until it reached the bottom of the slot.
To remove the memory card, gently push the top edge of the card
inwards and it will pop up slightly, then pull the card out of the slot.

Connect a USB Dongle

Use the USB Host cable and connect the small end with the USB Connector of the
Projector. Connect the USB dongle on the big end of the cable.
www.aiptek.eu
Charging Status
Page 8
Charging Time
around 3 hours
around 8 hours
no charging
no charging