Table des Matières
Publicité
5-3. Connecting To Power Source
6
.
The FieldPro Remote can only be
used with FieldPro power sources.
See welding power source Owner's
Manual for additional information on
safety, installation, operation, and
troubleshooting.
1
Power Source
2
TIG Torch (Shielding Gas Not
Shown)
5-4. Remote Interface Controls
3
4
FieldPro Remote Connection
3
Electrode Holder
4
Work Cable
Connect work cable to WORK (bottom)
output receptacle on the front of the weld-
ing power source. Attach work cable clamp
as close to the arc as possible.
5
Work Sense Lead
Attach work sense lead clamp next to the
work cable clamp. Connect the other end
11
10
5
6
1
4
of the work sense lead to the binding post
on the side of the FieldPro Remote.
6
FieldPro Remote
Connect one end of the weld cable to
ELECTRODE (top) output receptacle on
the front of the power source and the other
end to the FieldPro Remote. Connect the
TIG torch or electrode holder to the other
side of the FieldPro Remote.
.
The FieldPro Remote can only
be used with FieldPro power
sources. See welding power
source Owner's Manual for
additional
safety, installation, operation,
and troubleshooting.
1
AMPS Display
2
TIG Process Select Button
3
Stick Process Select Button
4
Stick Electrode Type Select
Button
5
Amperage Adjustment
Buttons
1
6
14-Pin Remote Connected
Indicator
2
7
FieldPro Accessory
Connected Indicator
8
IN USE Button
9
IN USE Indicator
10 Check Polarity Indicator
11 Stick Negative Indicator
7
8
9
5
2
3
255 420-B
information
on
Ref. 255 429-B / 264180−B
OM-265 461 Page 13
Publicité
Table des Matières
