Section 5 − Operation; Proper Method To Carry Remote; Connecting Work Sense Lead To Remote - Miller FieldPro Remote Manuel D'utilisation

5-1. Proper Method To Carry Remote

5-2. Connecting Work Sense Lead To Remote

4
.
The work sense lead is required for op-
eration of the FieldPro Remote.
1 Lead
2 Ring Terminal 1/2 in.
If using a ring terminal, slide terminal onto
post on the remote.
OM-265 461 Page 12
SECTION 5 − OPERATION
3
1
2
5
3 Wing Nut
Once terminal or wire is on post, tighten
wing nut.
4 Binding Post
1
5 Electrical Tape Or Heat Shrink
Tubing
If ring terminal is cut or broken, the bare
wire can be looped around the post and
tightened under the wing nut.
! Turn off welding power
source and disconnect input
power before making any in-
put or output weld cable con-
nections.
1 Handle
Carry Remote only by using the
handle.
255 409-B
2
5
255 450-A