ShelterLogic 25730 Instructions De Montage page 5

4. ANCHOrING AND rOPE TOGGLES
A. Thread the Guy Ropes
the rope to keep it from sliding out of the rope toggle.
B. Make a loop knot at the other end of the rope and place it over the tab the the top of the tent pole.
C. Place the anchor securely in the ground about 3' from each tent pole.
D. Tighten anchor rope with rope toggle.
This is a temporary spike anchor. Not intended for permanent use.
Thread Guy Rope Through Rope Toggle
10436
3'
5. TIGHTEN THE COvEr WITH CLAMP TWIST TITE
A. Mount the clamp and new TwistTite
holds onto the rope that is still threaded through
the canopy cover edges.
B. The clamp should be mounted approximately
6" to 10" up from the corners.
C. Wrap the cord with plastic ball and "S" hook at
the corners of the cover around the corner leg
poles. Insert "S" hook into the hole of the corner
leg poles.
D. Twist each leg pole toward the outside of the
shelter until the cover becomes tight.
Twist the leg poles equally to ensure the cover stays
aligned during tightening.
through the Rope Toggle
10437
Knot
10447
™ cable so it
as shown below. Tie a knot at the end of
10436
Top view Anchor Ropes Setup
12082
Ropes & Canopy
Anchors
™
Attach Clamp
Rope threaded
through edge
of canopy cover
Page 5
Top of Tent Pole
Spike Anchor
Clamp Twist-Tite ™
6" - 10"
10462
05-25730-0E