Volume Control - Peavey PV 1 VHF Mode D'emploi

feet, one or the other of the A or B LEDs may extinguish briefly. This is normal.
The unit's diversity reception ensures that the received audio will not be
interrupted. When both the A/B DIVERSITY LEDs and the LED RF LEVEL display
extinguish, the transmitter is out of range for that given location, and the user
should move closer to the receiver to re-establish the radio link.
4. Connecting the Audio Output
The PV 1 receiver provides both a fixed mic level BALANCED AUDIO OUTPUT
®
XLR (7) and an adjustable line level UNBALANCED AUDIO OUTPUT 1⁄4" JACK
(9). The level from the UNBALANCED OUTPUT is controlled by the rear panel
VOLUME CONTROL (8). (Note: As when making any connection, make sure the
amplifier or mixing board volume is at the minimum level before plugging in the
receiver to avoid possible sound system damage.)
A. Instrument Connection (using the PV1 instrument transmitter)
Insert an audio cord with a 1⁄4" mono phone plug in the UNBALANCED OUTPUT
JACK (9) on the rear panel of the receiver. Plug the other end of the cord into
an amplifier, effects, or mixing board. Adjust the VOLUME CONTROL (8) on
the PV-1 receiver clockwise until the volume level is comfortable for your
application. This setting is roughly equivalent to a direct instrument cord
connection.
B. Microphone Connection (using the PV1 transmitter with either a headset or
lavalier microphone or the PV1 handheld microphone transmitter)
For microphone use, either the BALANCED MIC AUDIO OUTPUT XLR (7) or the
1⁄4" line level UNBALANCED OUTPUT (9) can be used. The XLR output is set
at a non-adjustable microphone level, similar to hardwired mic levels. Plug
an XLR connector into the XLR output jack on the rear of the unit and plug the
other end into your amplifier or mixing board. (Note: Make sure mixing board is
turned off and the volume is turned down when making connections.) For your
convenience, the XLR output level is preset at the factory and is not adjustable
with the receiver volume control. To use the 1⁄4" UNBALANCED OUTPUT JACK
(9), follow the instructions for the Instrument Connection (above), except start
with the receiver volume at 1⁄2" MAX and adjust the volume control until the
volume level is optimal. If the volume control is set too high, you may overload
your mixer or amp.