Getting Started - Polycom SpectraLink 8020 Mode D'emploi

GETTING STARTED

Your SpectraLink 8020/8030 Wireless Telephone uses radio wave
technology to send and receive voice transmissions. It is designed to
operate like a cell phone. However, the handset uses the private telephone
system installed in your facility and will not operate outside the area
covered by this system. See the User Guide for detailed information about
how to use your handset.
The handset's Battery Pack must be fully charged before its
first use. Place the handset into the charger for a minimum of
two hours before using it. See the section Charger Models for
full information.
Basic Handset Operation Summary
If you want to Then
Remove the
Battery Pack
Replace the
Battery Pack
Turn the handset on
Turn the handset off
English
Press down on the latch on the Battery Pack at
the back of the handset and pull the Battery
Pack towards you. The Battery Pack releases
outward.
Slide the lip of the Battery Pack into the bottom
of the cavity. Push the top of the Battery Pack
until it snaps into place. You should not have to
force it into the handset.
Press and hold the
sound.
Press and hold the
sound. If you are in a call, hang up first, then
turn off the handset.
END
key until two chirps
END
key. One chirp will
5