Polycom SpectraLink 8020 Mode D'emploi page 11

Charger Models
Three charger models are available for the SpectraLink 8020/8030
Wireless Telephone. The Single Charger will charge a single handset with
an installed Battery Pack. The Dual Charger will charge the handset and a
spare Battery Pack. The Quad Charger can charge up to four Battery Packs
at a time. Any Battery Pack for the SpectraLink 8020/8030 Wireless
Telephone can be charged in any charger.
The Single and Dual Chargers allow the handset to remain operative in
speakerphone mode or with a headset while charging. Handsets may be
charged while in standby mode, while in an active call or while turned off.
Place the Single or Dual Charger on a flat, horizontal surface. Plug the
power supply into the charger and into an appropriate wall outlet. The
Quad Charger may be mounted on a horizontal or vertical surface.
Single Charger
Place the handset in the Single Charger facing forward. While the handset
is charging in standby mode, it will display its extension number and
Charging...
. An animated charge icon will indicate that charging is in
progress. The handset is fully operational and will ring if called. When the
Charging...
handset is charging while turned off, only will display and no
calls will be received. The dots will be racing during the charging cycle.
Charge Complete
When the handset is fully charged, will display.
Dual Charger
Place the handset in the front slot, facing forward. The Battery Pack alone
snaps into the charging bay.
The LED indicates the status of the Battery Pack in the rear bay. The
handset displays its charging status as described for the Single Charger.
When the handset is fully charged or is removed, the Battery Pack in the
rear slot will begin charging.
Note that the time it takes for the Battery Pack to charge will be lengthened
if its charging cycle is interrupted by the placement of a handset in the front
slot.
English 11