F.Bertazzoni REF31BMFIX Mode D'emploi page 13

Note：
In order to fix the water filter at the proper
position and avoid over bending the water
line (1/4"), you should determine the
distance from the shutoff valve to the filter
mounting location previously. Then cut the
water line (1/4") as required length.
3. After connecting the water line (1/4"),
please turn on the shutoff valve to flush
the filter for 5 minutes before use.
Note:
 The initial dark discoloration of water is
normal.
4. Connect the water line (1/4") with
refrigerator by a connector.
1) Fully insert the other head of the water
line (1/4") into the connector.
2) Fully insert the water line of the
refrigerator (at the right of the compressor
room) into the connector.
3) Insert two clips in the install pack as
shown below, and then confirm that each
clip holds the water line firmly.
 The water line (1/4") length should be
less than 5m. If the water line is too long
(>5m), the ice and cold water content may
be affected due to insufficient water
pressure.
13
Note：
The water line must be fully inserted into
the center of the connector to prevent
water leaking.
Fixing the water filter
To fix the water filter, follow these steps
below.
1. Determine the location to mount the
water filter.
Note:
 The water filter should be mounted on
the wall where it is convenient to be
replaced.
 Do not mount the filter onto the
refrigerator! Coolant
pierced!
2. Determine the distance from the shutoff
valve to the filter mounting location, and
the distance from the filter mounting
location to the refrigerator.
3. To avoid over bending the water line,
cut the water line (1/4") as required length
according to the determined distance
previously.
4. Mount the filter holder onto the wall by
using a screwdriver and attach the water
filter.
Warning!
 The water filter must be held upright as
shown in the figure. It is critical to connect
the water line tube into the filter inlet and
outlet correctly.
pipes might be