Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
L
I
3) Place the micro-fiber cloth pad onto the mop head and fasten the micro-fiber cloth pad by pulling
the cord while pressing the toggle.
4) When using the appliance on carpets, place the mop head - featuring the micro-fiber cloth - onto the
M
carpet glider
.
NOTE: Do not operate the appliance with the carpet glider without the micro-fiber cloth in place.
D
E
5) To add water to the water tank
, hold the appliance at a 45° angle, open the water tank cover
and
E
D
add water into the water tank . Close the water tank cover once the tank has been filled to the
maximum level.
F
6) Once the appliance is fully assembled and the water tank has been filled with water, unwind the power cord
completely and plug it into a grounded socket.
B
7) The power switch
will be in OFF position when "O" is pressed, and in ON position when "I" is pressed.
B
B
To switch ON the appliance, place the power switch
into "I" position; the power switch
LED will then
turn red. After approximately 20-35 seconds, the appliance will start emitting steam. Note: It is normal for a
little bit of water to be ejected from the nozzle before steam starts to appear.
8) Slowly pass over the intended surface. It is recommended to sweep or vacuum the floor prior to using the
appliance.
B
O
9) To stop emitting steam and to turn OFF the appliance, push the power switch
to the OFF
position;
the power switch LED indicator will then switch off.
D
10) Once finished cleaning, unplug the power cord from the socket, empty the water tank , wind the power
F
I
G H
L
cord
around the cord wraps
and carefully remove the cloth pad
from the mop head
.
CAUTION: the cloth pad may be very hot! Store the appliance upright in a dry area.
EN 04
Publicité
Table des Matières
