Power Source - Iridium Edge Pro Mode D'emploi

6.3 Select Cables
Only use cables that meet the Iridium Edge Pro's cable specifications and local regulatory codes.
All cables used to install the Iridium Edge Pro should be fabricated by a qualified cable assembly
shop.
Use proper cables. Use of improper cables can result in damages to equipment, property or persons.
Use power and ground conductors of proper gauge. Use of improper gauge power cables could
result in exposing cables to excessive heat which could cause fire, resulting in serious injury
or death.
6.4

Power Source

For all installations ensure that the power source
Meets all local electrical and regulatory codes.
•
Complies with the input voltage and maximum current specification of the Iridium Edge Pro
•
listed on the label. Never connect the Iridium Edge Pro to an AC power source.
6.5 Fuse Location
The Iridium Edge Pro should always be powered through a suitably rated quick-trip fuse. The fuse
should be located close to the power source.
The Iridium Edge Pro must be powered through a properly - rated fuse or current-
NOTICE
limited power supply. Failure to do so could cause large current drawings if unexpected or
inadvertent shorts occur in either the Iridium Edge Pro device or its mating cable. Any large
sustained current could result in damage to equipment.
Iridium Edge Pro User Manual
UM_Iridium Edge Pro_v1.1_072220
Figure 6-2: Spare IMEI Label
Page 21 of 26