Jam TWS EXEC Livret D'instructions page 3

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
SET UP
CHARGING YOUR EARBUDS
To charge your earbuds, place them into the portable
case. The red LEDs on the earbuds show that they are
charging. If the red LEDs do not appear when placed
in the case, adjust the earbuds to make sure they are
in line with the charging contacts. When fully charged,
the LEDs will shut off. It will take approximately 2
hours to charge.
CONNECT BOTH EARBUDS
STEP 1 – TURNING ON THE EARBUDS
Your earbuds will automatically turn on when taken
out of the portable charging case. If you need to turn
them on manually, yo u can press and hold the touch
sensor for 5 seconds on
both earbuds.
EN
5s
CHARGING YOUR PORTABLE CASE
Plug the small end of the USB cable into the micro
USB port, located on the back of the case. The LEDs
on the case will flash blue while charging. When the
portable case is fully charged, the four LED lights will
remain on. Once the USB cord is unplugged, the lights
will turn off.
STEP 2 – CONNECTING THE EARBUDS TO
EACH OTHER
When you take the earbuds out of their case, they will
automatically sync to each other. The LEDs on the left
earbud will flash blue and red alternatively. You will
also hear a series of tones. Your earbuds are now in
pairing mode and searching for a Bluetooth
to connect to.
double tap
If your earbuds don't sync to each other
automatically, tap both earbuds two times at the
same time on the touch sensors. This will put your
earbuds into sync mode, and the LEDS will flash blue
and red alternatively. Your earbuds should now be
connected and are in pairing mode and searching for
a Bluetooth device to connect to.
device
®
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hx-ep625

Table des Matières