Magic Vac PROFESSIONAL JUMBO 30 EVO Instructions De Fonctionnement page 5

1. Important Warnings
Simple safety standards to avoid danger for persons, animals and objects:
Read the instructions carefully before using your
For further details regarding use with accessories and for the Vacuum Guide, download the information on
The Manufacturer and the Seller are deemed responsible for safety, reliability and performance only if: a) the machine is used in compliance to the use
instructions; b) the electrical system of the environment in which the machine is used is compliant to laws in force.
Before first use, and periodically throughout the product's life, check the power cable to ensure there is no damage; if the power cable is damaged, it must be
replaced by the manufacturer, by the service agent or by a third appropriately qualified party in order to avoid eventual risks.
It is not a device for continuous use. Do not carry out more than one complete cycle every 2 minutes. The operative cycle duration is about 50 seconds, which
must be followed by a pause for up to 2 minutes. In extreme environmental conditions, intensive use of the device can set off the automatic thermal protection
systems. In this case, wait for the device to cool down to the point that allows resetting of said protection systems.
Never use power voltage adaptors different from the voltages reported on the device (see tag data).
Do not immerse the device in water and do not use if the cable or plug are wet; if this should happen during use, immediately disconnect the plug wearing dry
rubber gloves. Do not extract or touch the device immersed in water before having disconnected the plug from the socket. Do not use after having removed it
from the water (immediately send to an authorized assistance centre or your local reseller.
Do not use the machine with bare feet. The machine is not protected against fluid penetration.
This machine is not intended for use by persons (including children) with reduced physical, sensory or mental abilities, or persons without the necessary
experience and knowledge, unless a person responsible for their safety monitors their use of the machine or has supplied them with all the information
necessary.
Always ensure that children are not playing with the machine.
Switch off the machine using the switch after each cycle, and always disconnect the plug after use and during cleaning and maintenance.
Do not use the machine near or around hot surfaces. Do not touch the sealing bar during use or at the end of the machine cycle, in order to avoid possible
burns. Do not use a knife or other sharp tools to remove eventual residue on the sealing bar; always wait for it to cool off before cleaning with a moist sponge or
light detergent.
Do not use cracked or damaged lids or containers!
2. Work cycle
Place the machine in a dry area on a horizontal plane, clearing the work station in front of the machine itself from obstacles, and ample enough to set the bags of
foods to pack. Connect the Power cable (1) plug to the Power Socket (2) on the side of the machine, then connect it to a mains socket with the corresponding
voltage of the same (see tag data). Then press the Main switch (3), on the side of the machine; its display will show a lit ON green LED indicator (3a), and the
red LED indicator (7b) for (AVERAGE) sealing time, which you may change to MIN if you're packing dry foods or MAX for very moist foods.
Use the "STOP/CANCEL" (9) button to interrupt the started cycle at any time.
Packing in bags
®
Use only original MAGIC VAC
Automatic Cycle
a) Insert the food in the bag without creating particular creases or tension on the surface. Eliminate liquids or food residues from the inner zone of the bag opening
which must be sealed.
b) Lift the Lid (13) and lay down the bag with its content placing the open extremity inside the Removable Fluid Tray (15) (see Fig. E) with the smooth part facing
up.
c) Lower the Lid (13) pressing on the two extremities P until locking the Side hook-up levers (12) (fig. B). You can check the correct positioning of the bag in the
vacuum chamber through the Porthole (13.a)
d) Press "A" (4) for automatic cycle. The machine will carry out the complete packing cycle.
e) Wait for the red LED on the "T " (7) (fig. A) button to stop flashing, then unlock the Lid (13) pressing on both Side hook-up levers (12) and lastly remove the
bag.
f) Check the validity of the seal obtained which will have to look like a regular cross stripe, without creases and streaks inside the bag.
Manual Cycle (To limit air extraction and not crush delicate and fragile foods)
a) Repeat operations from a) to c) of the Automatic Cycle
b) Press "M" (5) (fig. A) to start-up the manual vacuum cycle. Then, before the fragile and delicate content of the bag is crushed, activate sealing by pressing "S"
(6) (fig. A). This way the vacuum cycle is interrupted by sealing the bag immediately.
c) Then repeat operations from e) to f) of the Automatic Cycle
Obtaining a bag from the roll
Before repeating operations from a) to f) of the Automatic Cycle or from a) to c) of the Manual Cycle, proceed as follows:
a) Unroll the suitable length of the roll, considering at least 8 cm more than the overall dimension of the food to pack and an additional 2 cm for each time that the
bag will be used subsequently. Then, cut that part using the MAGIC Cutter (20) bag cutter (see Fig. D)
b) Now you can seal an open side of the part by lifting the Lid (13), placing the open extremity on the OUTSIDE of the Removable Fluid Tray (15) with the
smooth part facing up (fig. F) and lastly press "S" (6) (fig. A). Attention: do not let the bag protrude towards the Removable Fluid tray (15) or on the
Gasket (14), but set the extremity against the external part of the Gasket (14) (see Fig. F).
Packing in Containers
ATTENTION:
Exclusively and only use MAGIC VAC
manufacturers could implode and cause injury.
a) Connect the Container to the machine, inserting the extremity of Pipe (21) in the Vacuum Connection(11) (fig. A) and on the Container lid, turning its knob
according to the instructions supplied with the Container itself.
b) Press "C" (8) (fig. A); the machine will carry out the vacuum cycle automatically and will switch off when the operation is complete. The pump switches off
automatically after approximately 5 minutes. At the end of the cycle, extract the Pipe (21) from the Container and then from the Vacuum Connection (11) of
the machine.
Quick marinating
With the exclusive "Quick marinating", function, the machine keeps the vacuum in the container for several minutes, then automatically releases it, allowing the
food to "rest" for 30 seconds. This pulsating vacuum and rest action is repeated again and again and allows for much quicker marinating. Only use the specific
®
square MAGIC VAC Executive 2.5 litre original container(code ACO1073)
a) To marinate meats, poultry or fish, perforate the surface of the food and place it in the container, covered with the marinade of your choice, leaving at least 3
cm from the top container border, and placing the lid on the container. Hook up the container lid safety latches then rotate the knob to "OPEN - (M)".
NOTE: Make sure that the lid gasket and the container border are dry and clean.
b) Using the Pipe (21) connect the container lid knob to the Vacuum connection (11) of the machine (fig. A).
c) Press "M" (9) , indicated by the lit blue LED indicator (9.a) above, which will remain steadily lit during the vacuum phase and flashing in the standby phase. The
machine switches off automatically after the third vacuum phase, emitting an acoustic signal (beep). The entire complete cycle lasts about 12 minutes.
NOTE: At the end of the cycle, if you wish to keep your marinade vacuumed, rotate the container knob to "CLOSED" position.
d) Disconnect the Pipe (21) first from the container, then from the machine air inlet. Lastly press "STOP/CANCEL" (9) to end the cycle. The machine can be
stopped at any time by pressing "STOP/CANCEL" (9); to repeat the marinating operation, disconnect the pipe from the container and wait for the container to
completely fill with air. Reconnect the Pipe (21) to the container knob (in OPEN - M position), then restart the quick marinating cycle by pressing "M" (9).
3. Cleaning
ATTENTION: Always disconnect the power cable before cleaning MAGIC VAC
Before and after use, clean the accessible machine surfaces with a moist sponge and neutral detergent, or denaturized alcohol or white vinegar diluted in water,
Do not use aggressive detergents or solvents or aromatic extract based products on the plastic parts!!!! Also, wrong use of chlorine or detergents
based on hydrochloric acid, muriatic acid, hydrofluoric acid and sulphuric acid (like some water softeners ), can ruin the typical stainless steel shine and
sometime irrevocably affect its resistance.
®
MAGIC VAC Jumbo 30 Evo
bags and rolls.
®
containers, because they are resistant to the vacuum value obtained by Jumbo 30, while containers by other
and keep them handy for future reference.
www.magicvac.com
®
.
3