Location; Electrical Connection; Rear Spacers - AEG S65340KG2 Notice D'utilisation

Climate class
SN
N
ST
T

Location

The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Ensure that air can circulate freely
around the back of the cabinet. To ensure best
performance, if the appliance is positioned be-
low an overhanging wall unit, the minimum dis-
tance between the top of the cabinet and the
wall unit must be at least 100 mm . Ideally, how-
ever, the appliance should not be positioned be-
low overhanging wall units. Accurate levelling is
ensured by one or more adjustable feet at the
base of the cabinet.
WARNING!
It must be possible to disconnect the appliance
from the mains power supply; the plug must therefore be easily accessible after installation.

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the rating plate cor-
respond to your domestic power supply.
The appliance must be earthed. The power supply cable plug is provided with a contact
for this purpose. If the domestic power supply socket is not earthed, connect the appli-
ance to a separate earth in compliance with current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Directives.

Rear spacers

In the bag with the documentation, there
are two spacers which must be fitted as
shown in the figure.
Slacken the screws and insert the spacer under
the screw head, then tighten again the screws.
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Ambient temperature
A
3
31
Installation
B
2
1