Klarstein WINDWAKER Mode D'emploi page 53

• Don't share the socket with other electric appliance. Otherwise, it may cause
electric shock even fire and explosion.
• Always switch off the device and cut the power supply before performing any
maintenance or cleaning. Otherwise, it may cause electric shock or damage.
• Don't pull the power cable. The damage of pulling power cord will cause serious
electric shock. A warning that ducts connected to an appliance shall not contain an
ignition source.
• Do not install air conditioner in a place where there is flammable gas or liquid. The
distance between them should above 1 metre. It may cause fire even explosion.
• Do not use liquid or corrosive cleaning agent wipe the air conditioner and sprinkle
water or other liquid either. Doing this may cause electric shock or damage to the
appliance.
• Do not attempt to repair the air conditioner by yourself. Incorrect repairs may cause
fire or explosion. Contact costumer service or a qualified service technician for all
service requirement.
• Do not use air conditioner in lightning storm weather. Power supply should be cut in
time to prevent the occurrence of danger.
• Don't put hands or any objects into the air inlets or outlets. This may cause personal
injury or damage to the appliance.
• Please note whether the installed stand is firm enough or not. If it is damaged, it may
lead to the fall of the unit and cause the injury.
• Don't block air inlet or air outlet. Otherwise, the cooling or heating capacity will be
weakened, even cause system stop operating.
• The appliance shall be installed in accordance with national wiring regulations.
• An earth leakage breaker with rated capacity must be installed to avoid possible
electric shocks.
• Ensure no following objects under the indoor unit:
1. microwaves, ovens and other hot objects,
2. computers and other high electrostatic appliances,
3. sockets that plug frequently.
• The joints between indoor and outdoor unit shall not be reused, unless after re-
flaring the pipe.
• The appliance may only be used in conjunction with AC sockets with CE marking.
The requirements for the socket are stated on the type plate of the appliance.
• If your air conditioner is not fitted with a supply cord and a plug, an anti-explosion
all-pole switch must be installed in the fixed wiring and the distance between
contacts should be no less than 3.0 mm.
• If your air conditioner is permanently connected to the fixed wiring, a anti-
explosion residual current device (RCD) having rated residual operating current not
exceeding 30 mA should be installed in the fixed wiring.
• The power supply circuit should have leakage protector and air switch of which the
capacity should be more than 1.5 times of the maximum current.
EN
53