Virax NETTOYEUR-DEBOUCHEUR HP PRO Manuel Utilisateur page 25

ASSEMBLY - Fig. 3 to 8
Fig. 3 –
Reel holder for electric cable or unclogger.
Fig. 4 –
Reel handle (Apply the plastic cap: avoids oxidation of the screw).
Fig. 5 –
Quick coupling (3/4" F) water inlet cleaner-unclogger.
Main filter (50 μ) inside the coupling: DO NOT FORGET OR LOSE IT!
Fig. 6 -
Quick coupling (3/4" F) FEMALE / Water supply hose: Inlet cleaner-unclogger. It is
recommended that a well known brand connection device be used (more reliable) and a coupling
fitted with a non return valve.
Fig. 7 -
Quick coupling (3/4" F) FEMALE / Water supply hose: FAUCET inlet.
In accordance with the EN1717* standard relating to direct suction high pressure
cleaners: No High pressure cleaner can be connected to the drinking water supply
EXCEPT if it is equipped with an anti-backflow device (so called "BA Valve").
Additionally, the length of the water supply hose must be of at least 12 m (minimum Ø 19.1 mm)
in order to regulate possible pressure peaks in the network.
* Failure to comply with this standard is the sole responsibility of the user; in no way can the manufacturer or
distributor, whose sole responsibility is to issue the warning ,be held responsible for failure to comply.
Fig. 8 –
Secondary FINE (300 μ) filtration system / Water supply faucet (3/4" ) : Use is optional
but recommended to protect the high pressure pump.
PREPARATION - Fig. 9 to 13
Fig. 9 –
Winding of the HP hose on the reel (be sure to wind the coils well)
Fig. 10 –
Reel BRAKE: RED lever.
Be sure to unblock it before winding or unwinding the HP hose.
Do NOT FORCE THE HANDLE!
Fig. 11 –
Fitting the selected LANCE (A= Multijet / B= ROTARY NOZZLE) on the gun.
Fig. 12 –
Fitting the HP hose on the gun.
Fig. 13 –
Fitting the Pipe UNCLOGGER on the gun.
About the ASSEMBLY / DISASSEMBLY of the accessories
DO NOT TIGHTEN TOO MUCH!
The female coupling of the hose is fitted with a spigot which has an o-ring to ensure
watertightness, the latter is hence garanteed even with low tightening torque.
DISCHARGE PRESSURE BEFORE GOING ABOUT ANY CHANGE OF ACCESSORY!
Under pressure, it is difficult to untighten the coupling by hand and this results in damage to the
seals ...
To discharge pressure: Turn the device off and simply press the trigger.
All the accessories have a universal M22 coupling: As this is the norm on the HP market, you will
be able to fit your device with additional tools, keeping costs to a minimum
English
25