Futurelight CP16 Mode D'emploi page 13

the program button. The programs you have chosen are once run through from the lowest to the highest
number. The controller runs through the program run until you stop it by erasing the dot. You can erase the
dot by pressing the program button once more.
CAUTION: The program run is not memorized. As soon as you turn the device off, the program run is lost.
Programming:
Choose one of the freely programmable chasers between 1 and 10 with the program button (e.g. program 1).
Press the write button and the display shows „00" (flashing). Choose the desired projectors with the projector
select buttons. The respective LED has to flash.
Press the speed button in order to adjust the speed. The display shows the current speed. Choose e.g. the
standard speed 5, which provides a high memory frequency (10x/sec.) and a short program duration. This
speed is particularly suitable for slow movements as the high frequency provides soft beam movements. You
can choose the speed between 1 (50x/Sec.) and 99 (1x/2Sec.).
Adjust the settings with the Gobo/Strobo Up/Down buttons and the Colour Up/Down buttons.
Move the mirror with the joystick to the starting position.
CAUTION: As soon as you press the write button, the program starts running.
Press the write button and the two bars „--" on the display start moving. Make the beam movement with the
joystick and adjust the settings as desired.
If you want to stop the programming, press the write button once more. Otherwise, the programming stops as
soon as the program runs out of memory capacity (depending on the speed you have chosen).
CAUTION: The programming is only memorized in a volatile memory. This means that all freely
programmable programs are lost if you reset the controller.
Shortening a freely-programmable chaser:
Choose the freely-programmable chaser with the program button. Choose the desired projectors with the
projector select buttons. The projector LED has to be permanently on.
Press the write button, the chaser starts running and the two bars „--" on the display start moving. Stop the
program by pressing the write button once more.
Erasing the volatile memory (RESET):
CAUTION: All of the 10 freely-programmable chasers are erased. The 10 pre-programmed scanner
programs cannot be deleted.
Turn the controller off, turn it on again. While the controller checks the LEDs, press the program button and
hold it until all LEDs start flashing. Press the write button in order to confirm the RESET.
TECHNICHAL SPECIFICATIONS CP16:
Power supply
Power consumption:
Fuse:
Sound input:
Impedance:
DMX-Output:
Plug connection:
Dimensions:
Weight:
Please note: All specifications are subject to change withour prior notice.
12/96 © Errors and omissions excepted.
230V/50Hz
10VA
100mA slow blow
¼ " (6,3mm) Jack plug mono
15KOhm
¼ " jack plug stereo
DMX-512, channels 1-16
Tip=Data+, Ring=Data-, Sleeve=Mass
483 x 88 x 80 mm
1.7 kg
13