Scell-it ELEMENT SPLIT S Manuel D'utilisation page 5

ADJUSTING THE TOOL
1- NUT POSITIONNING
1
• Screw the nut onto the mandrel
• Set the mandrel legth by adjusting the piece
2- ADJUSTING THE STROKE
1
2
3
4
YES NO
A B
2 3
automatically by exercising light pressure on the nut.
1
2
The mandrel must come through the nut as indicated in the picture.
Then remove the nut before adjusting the stroke.
According to the nut and the support thickness the stroke must be
adjusted to provide ideal installation.
Adjusting of stroke is done by screwing/unscrewing the piece
See graduations on the piece
0 : minimum stroke
It is recommended to adjust the scale set on 2 and to do installation
trial.
Adjusting the stroke is necessary to obtain the desired deformation.
NO
C
4
.
:
3
9 : maximum stroke
A Correctly set
B
Not fully set
C
Over-set. Do not pull the nut up
too tightly as you may strip the
thread in the nut or damage the
tool mandrel.
ELEMENT SPLIT - User Manual
EN
FR
PL
CZ
.
4
• 5