Flush Receiver - Watts BT-FR-02 Guide D'utilisation

GB
1. Presentation
- The receiver is a Wall mounting receiver, specially designed to control electrical floor heating regulation in combination or
not with a wireless thermostat type.
- This couple (Thermostat Receiver) can also be managed by a Central to have full control of your heating installation from
one point.
- Possibility to connect a floor sensor directly on this unit (For regulation or floor limitation).
Output LED (Red)
Red: Heating demand
Blink: Floor sensor error
RF Configuration button
Short press: Instantaneous RF transmission
3sec press: Thermostat or Central RF init.
5sec press: Slave receiver init.
15sec press: Reset of the receiver.
2. Technical characteristics
Environment. (Temperatures)
Operating :
shipping et storage :
Power supply
Electrical protection
Pilot wire Input (French market)
Output
Maximum Load
Radio Frequency &
RF Receiving distance
Optional Floor Sensor
CE Directives
Your product has been designed in
conformity with the European Directives.

Flush Receiver

Option: Floor Sensor
NTC 10kOhms at 25°C
0°C - 40°C
-10°C to +50°C
230Vac 50Hz
Class II - IP20
Option: insulation clip for IP21 protection
6 orders Pilot Wire by phase (L)
Relay 16Amps 250VAC
Up to 16A - 250Vac 50Hz (2 wires L,N)
868MHz < 10mW (Bidirectional communication)
Range of approximately 100m in open space.
Range of approximately 30m in residential environment.
NTC 10kOhms at 25°C
R&TTE 1999/5/EC
LVD 2006/95/EC
EMC 2004/108/EC
RoHS 2011/65/EU
4
Status LED (RED/Green)
Green:
Fixed: RF configuration
Flash: RF reception
OFF: Standby
Blink: RF Alarm
Red:
Fixed: Floor Limitation
Red/Green (Orange)
Fixed: Pilot wire information.