Maintenance - Husqvarna T 4000 Manuel D'utilisation

A
B
To monitor the filter conditions
The product has a manometer to monitor the filter
conditions. The manometer shows the total load of the
product in 3 levels, (A) maximum vacuum level (0m/s),
(B) filter cleaning level and (C) level without load.
Introduction
WARNING:
equipment, refer to
equipment on page 7 , during service. Dust
can be exposed during maintenance and
service.
WARNING:
machines occur during trouble shooting,
service and maintenance as staff have to
locate themselves within the risk area of the
877 - 006 - 03.02.2022
180°
B
A
C

Maintenance

Use personal safety
Personal protective
Most accidents involving
1. Clean the prefilter if the manometer is above the
filter cleaning level (B). Refer to
filter on page 10 .
2. Replace the Hepa filter filter if the suction continues
to be not sufficient. Refer to
filter on page 11 .
machine. Prevent accidents by being alert
and by planning and preparing the work.
WARNING:
switched off during operations described in
this chapter unless otherwise stated.
WARNING:
components should only be performed by a
licensed electrician.
To clean the pre
To change the Hepa
The motor should be
All checks involving electric
9