Outbound 079-4100-2 Manuel D'utilisation page 8

Q UICK-ST RT DEMONSTR TION
VI. Press the MODE touchpad again (*)
a. A flashing indicator will point toward IRON.
b. The flashing indicator tells us that iron has
been eliminated from detection.
VII. Wave the Nail over the Searchcoil
a. The nail will not be detected.
b. The nail has been "Discriminated Out."
VIII. Wave the Quarter, Penny, and Pull-Tab
over the Searchcoil
These non-ferrous objects will be detected with their own
distinctive tones.
IX. Press the MODE touchpad again (*)
a. The detector will beep twice and the sensitivity setting will flash on
the left side of the display.
b. Notice the flashing arrow pointing toward iron.
The flashing arrow indicates that this target category is currently
"Discriminated Out."
X. Press the MODE touchpad again (*)
The flashing arrow will now point
toward MID-RANGE.
XI. Wave all objects over the Searchcoil
The pull-tab and zinc Penny will not
be detected.
The other objects will be detected
with their own distinctive tones.
XII. Toggle modes by pressing the MODE
touchpad again (*)
a. Press once to see the current discrimination status of the detector
(MID-RANGE).
b. Then press again to toggle to the third discrimination setting.
i. Iron is eliminated.
ii. Mid-range metals are eliminated.
iii. Only high-tone metals like silver and copper will be detected.
(*) Note: The mode status will flash for 10 seconds. After 10 seconds,
mode status will time-out and stop flashing.
8