RotoZip RZ1500 Consignes De Fonctionnement/Sécurité page 10

RZ 2610011540 07-10:RZ 2610011540 07-10 7/12/10 2:50 PM Page 10
Disconnect the plug from
W RNING
the power source before
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting
the tool accidentally. Make certain that the
collet nut is securely tightened before turning
the tool on.
INSTALLING BITS
The bits are held by a collet system. Use either
the 1/8" (.125"), 1/4" (.250") or 5/32" (.156")
collet depending on the size of the bit shank.
The bit flutes are sharp and
W RNING
should be handled with
caution.
Depress and hold the shaft-lock in and rotate
the collet nut and shaft until the shaft-lock
engages and holds the shaft.
To prevent damage to tool.
C UTION
Never use the shaft lock as a
braking devise to stop the tool from rotating.
Use the standard equipment wrench to
loosen nut (counter-clockwise) (Fig. 2).
Remove the old bit (if there is one) insert the
new bit as far in as possible, but not so far
that the bit flutes engage the collet (leave
SH FT
LOCK
Assembly
The depth guide assembly consists of the
depth guide, locking screw and bracket.
In order to remove the depth guide from the
tool, release the locking lever and pull the
entire assembly straight off of the tool. To
reattach the assembly, fully replace the guide
onto the tool collar and lock the clamp lever
(Fig. 1).
approximately 1/8" of shank exposed)
Re-engage the shaft-lock and tighten the nut
(clockwise) by hand and then with the
wrench until bit is held securely.
The 1/8" collet is used with 1/8" diameter
bits, the 1/4" collet is used with 1/4" diameter
bits and the 5/32" collet is used with 5/32"
diameter bits. To change collets, first
remove the bit. Continue to loosen and
unscrew the collet nut until you can remove it
from the tool. Remove the collet and replace
it with the other (Fig. 3). (Each collet is
double-ended, and either end is acceptable
to use.) By hand, re-tighten the collet nut
around the collet in a clockwise direction.
You are now ready to insert a new bit as
instructed in Installing Bits (Fig. 2).
FIG. 2
1/8"
COLLET
NUT
-10-
REMOVING AND INSTALLING THE
DEPTH GUIDE ASSEMBLy
CHANGING THE COLLET
OUTPUT SH FT
FIG. 3
COLLET
COLLET
NUT