Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS (cont'd)
B. Base Assembly
•Align the two portions of the circular base and snap together by
gently pushing the 4 round extrusions (Fig. 7, Item A) into the
adjacent circles of the connecting piece (Fig. 7, Item B)
C. Securing the Pedestal to the Base
• Line up the arrow marked as
marked as
with the 3 holes in the base.
• Secure the base assembly to the pedestal by inserting and
tightening the 3 thumb screws in the 3 holes located on the
bottom of the base. (Fig. 9)
D. Securing the Tower Fan to the Pedestal
• Carefully turn the fan on its side. Place the power cord through
the center of the pedestal and base assembly.
• Align the pedestal arrow marked as
arrow marked as
the pedestal assembly clockwise to lock the tower fan in place.
•Secure the pedestal to the tower fan by inserting and tightening
1 thumb screw in the opening located near the top rear of the
pedestal assembly. (Fig. 11)
• With the fan still on its side, locate the cord holding bracket on
the bottom of the base.
• Gently pull any slack out of the power cord, place the power
cord securely in the holding bracket and secure the power cord
bracket over the power cord. (Fig. 12)
Note: Only one thumb screw is needed for the low height
option. Do not discard the additional screws as they will be
needed for Tall Height Option
• Locate the remote control that has been provided with the tower
fan. Make sure that the remote control is not thrown out with
• Install batteries into the remote control battery compartment
on the top of the fan. (Fig. 13)
on the base. (Fig. 8) Align the 3 round extrusions
. Firmly hold the base steady and rotate
on the pedestal with the arrow
with the tower fan
Fig. 7
A
B
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Publicité
Table des Matières
