Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION GUIDE
B/ Starting:
Stand alone:
ODM808 features a web server allowing control from you favorite web browser. Open your
browser, enter ODM IP address into the address window. Default factory IP address is
192.168.0.80
http:// 192.168.0.80
You can now access Web pages, to configure the equipment, which network settings
Attention, in case of difficulties, follows the procedure in "technical tools"» annex.
Use on a net:
Connect ODM to the net using the RJ45 connector. To work properly the ODM IP address
should be unique on the network, and in the available IP range. Should the PC or routeur net
differ from ODM808, first modify PC or routeur to the same net as ODM808, then set ODM IP
address as described in "technical tools" annex.
C/ Procedure to modify default IP address :
It is possible at any time to modify the default IP address. To do this connect a computer to
the front panel USB port.
Disable the front panel "OK battery" light, using the switch located on the right hand side of
this light. (cf user manual page 26 number 9).
Then disconnect mains cord. ODM is now off.
Now plug again in mains, ODM808 starts in BootLoader mode. Just disconnect USB wire,
ODM 808 restart in normal mode with default IP address 192.168.0.80.
note : Do not forget to push again the switch on the right hand side of light "ok battery"
(9) to use the battery back up, in case of power fail.
Rami
USB
GPI
1
2
3
4
5
6
7
8
1
2
32
GP0
OPTIONAL TUNER
BATTERIES
3
4
5
6
7
8
YES
NONE
CHARGE
OK
9
Next
Site Monitoring
ON
0
10
VOLUME
PHONES
ODM808
Publicité
Chapitres
Table des Matières
