asalvo CRECE FIX Manuel D'instructions page 23

3. Move the headrest of the child seat up to the highest position.
4. First take the cover off the base of the headrest, then remove the cover of
the headrest.
To re-fit the cover, simply follow the above steps in reverse.
CAUTION! Never use the child seat without a correctly installed buckle.
Make sure that the metal plate is correctly attached.
CAUTION! Check that the harness straps are not twisted and that they have
been correctly inserted in the belt slots of the cover.
4
ADJUST THE ANGLE OF THE
CHILD SAFETY CAR SEAT
This child safety car seat can be
adjusted to 4 positions.
Before fixing a child in the child
restraint system, the seat must be
set on the recline position for rear-
facing use, lying level or in the siting
position for forward-facing use.
To achieve this, use the recline
handle located in front of the child
restraint system between the seat
and the base to adjust it to the
desired position.
Four levels of inclination are possible.
5
ADJUST SAFETY BELT
LENGTHEN
A. Tighten Safety Belt
Pull up shoulder belt and the lap belt
will tighten, then pull crotch belt to
tighten safety belt.
INSTRUCTIONS
EN