Integrated System Monitor; Remote System Monitor - CycloVac GS Série Mode D'emploi

Integrated System Monitor

your central vacuum unit is equipped with an electronic timing device which will
recommend by a series of light emitting diodes (LeDs) proper maintenance of
your vacuum system. these signals are only suggestions and will do not indicate
a problem with your vacuum system. they will not stop or hinder the use of the
vacuum.
When you initially plug in your vacuum, the LeDs will signal "oK". then, according
to the number of hours the system has been use the LeDs will suggest the proper
preventive maintenance.

Remote System Monitor

Installed in a strategic location in your
home, it provides the same information as
the Integrated System monitor. once you
have reset the electronic timing device (on
the unit itself), the remote monitor will once
again signal "oK".
22
oK, system is operational
change the bag
change the carbon dust filter
Have the vacuum power unit inspected by an
authorized service center
reSet – press to stop flashing diodes and reset the
electronic timing device.
operating Instructions
(GX series only)
(Optional — GX series only)