CycloVac GS Série Mode D'emploi page 17

Installing the Remote Monitor
Connections on the Vacuum Power unit
1. Having stripped the exterior casing of the
four-stranded wire, strip 0,5 cm (¼") of
each color wire.
2. connect wires to the power unit
connector. Insert each wire in the
designated inlet, of the corresponding
color. to do so, simply open the
connector, insert the wire, and close
(figure 15). repeat for the remaining 3
wires.
(Optional — GX series only)
Installation
figure 15
a. red
B. Black
c. Green
D. yellow
17