Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTION MANUAL
JUG KETTLE
SAVE THESE INSTRUCTIONS!
PRODUCT DESCRIPTION
1 – Spout; 2 – Lid; 3 – Open button; 4 – Handle;
5 – Stainless steel body; 6 – Base, 7 – Keep Warm but-
ton; 8-11 – Temperature selection button;
12 – Power button.
•
Intelligent temperature control heating; with
optional 40°C, 70°C, 90°C, and 100°C heating;
•
Intelligent insulation; with optional 40°C, 70°C, and
90°C
•
Six touch key + 6 LED luminotron tube + buzzer
operation indication;
•
START/CANCEL key: To start / stop heating;
•
HOLD TEMP key: Select or cancel the insulation;
40°C -100°C water temperature key: To select the
•
required temperatures of 40°C, 70°C, 90°C, or 100°C;
•
Six indicator lamps are set on the base, to indicate
the selected temperature (40°C, 70°C, 90°C, and
100°C) and the insulation and power turning-on
indication function.
IMPORTANT SAFEGUARDS
When using your kettle, basic safety precautions should
always be followed, including the following:
1. Read all instructions carefully, even if you are familiar
with the appliance.
2. Close supervision is necessary when any appliance
is used by or near children.
3. Before connecting the kettle, check if the voltage
indicated on the appliance corresponds with the
mains voltage in your home. If this is not the case,
contact your dealer and do not use the kettle.
4. Switch off and unplug from the outlet before filling,
emptying or cleaning, or when not in use.
5. Do not overfill as boiling water may be ejected. The
maximum level is marked on the kettle.
6. Do not operate or place any part of this appliance
on or near any hot surface (such as gas or electric
burner or in a heated oven).
7. Do not let the cord hang over the edge of a table
or counter. Do not let the cord touch hot surfaces.
8. Never yank on the cord as this may damage the
cord and eventually cause a risk of electric shock.
9. If the supply cord of this appliance is damaged, it
must only be replaced by a repair shop appointed
by the manufacturer, because special purpose tools
are required.
10. Avoid touching hot kettle surfaces - use the handle
and the knobs.
11. To avoid possible steam damage, turn the spout
away from walls or cabinets when operating the
kettle.
12. If operated on wood furniture, use a protective pad
to prevent damage to delicate finishes.
13. To avoid scalding, always ensure the lid is correctly
positioned before operating.
14. Scalding may occur if the lid is removed whilst
heating.
15. Extreme caution must be used when moving the
kettle containing hot water. Never lift the kettle by
it's lid. Always use the body handle.
16. Do not switch your kettle on if it is empty.
17. To protect from electrical hazard, do not immerse
this kettle or cordset in any liquid.
18. Use the kettle only with the supplied base unit. Do
not use the base unit for other purposes.
19. To protect against fire, do not operate in the
presence of explosive and/or flammable fumes.
20. A kettle should not be left connected to a wall
socket when the room temperature is likely to
fall to outdoor winter temperatures. At sub-zero
temperatures the automatic control thermostat
may reset to boil and energize the element.
21. Do not use the kettle for any purpose other
than heating water. Other liquids or food will
contaminate the interior.
22. This product has not been designed for any other
uses than those specified in this manual.
23. This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
24. Children should be supervised to ensure that they
do not play with the appliance.
25. Repairs and other work undertaken on the unit
must only be done by authorised specialist
personnel!
WARNING:
Compare the local voltage with the voltage declared
on the device.
2
INSTRUCTIONS FOR USE
Before first use, fill the kettle with clean water to
maximum capacity and boil. Discard the water and
repeat.
1. The kettle should always be unplugged when
filling or adding water.
2. Fill the kettle with water to the desired level. Do
not overfill or there will be a risk of spillage or
spitting. Do not forget to close the lid after filling,
otherwise the kettle will not automatically switch
off after use.
Do not fill with less than 0.5 litre of water (up to
„MIN" indication) to prevent the kettle runnning
dry while operating.
3. The corresponding indicator will be on if the
heating temperature is set, so the heating will start
if the
heating button presses. The indicator
will flash, the buzzer will beep twice and the
temperature indicator will be on if up to the setting
temperature, so the kettle is at the standby state if
no any other operation for one minute.
4. Press the insulation button twice to start and press
it again to cancel. Only the 40°C, 70°C, and 90°C can
be selected for insulation rather than 100°C. If the
insulation function has been selected, this function
will be canceled if the temperature is set to 100°C.
In case of the insulation function selected, if the
heating button can not be pressed within one
minute, the insulation function will be canceled to
enter into the standby mode.
In case of the insulation function selected, if the
heating button is pressed within one minute, the
insulation timing of 60 minutes will count down.
5. In the heating process, if the temperature
indicator flashes, there indicates the setting heat
temperature; if this indicator is on, the water
temperature has been up to or above this setting
value;
6. If the insulation function has been not selected, the
kettle will be lifted up from the base to enter into
the standby state, so the program will be initialized.
In case of the insulation function selected, if the
kettle is lifted up from the base, this state before
lifting will be kept; if the base can not detect the
kettle within one minute, the beep sound will
be given to enter into the standby state and the
program will be initialized; if the base can detect it
within one minute, the front lifting will continue on.
In standby mode, all LEDs are off and the heating
process stops.
In standby mode, if there is no kettle on the base, all
buttons and indicators disable.
HOW TO CARE FOR YOUR KETTLE
Wipe the exterior of the kettle with a soft, damp
cloth or sponge. Remove stubborn spots with a cloth
moistened with mild liquid detergent. Do not use
abrasive scouring pads or powders. Never immerse the
kettle in water or other liquids.
From time to time depending on the nature of your
water supply, a lime scale deposit is naturally formed
and can be found mostly adhered to the heating
element and reduces the heating capacity. The amount
of lime scale deposited (and subsequently the need
to clean or descale) largely depends on the water
hardness in your area and the frequency with which
the kettle is used.
Limescale is not harmful to your health. But if poured
into your beverage, it can give a powdery taste to
your drink. Therefore, the kettle should be descaled
periodically as indicated below:
DESCALING
Descale the kettle regularly. With normal use, at least
twice a year.
1. Fill the kettle up to „MAX" with a mixture of
one part ordinary vinegar and two parts water.
Switch on and wait for the appliance to switch off
automatically.
2. Let the mixture remain inside the kettle overnight.
3. Throw the mixture away next morning.
4. Fill the kettle with clean water up to „MAX" and boil
again.
5. Throw away this boiled water to remove any
remaining scale and vinegar.
6. Rinse the inside of the kettle with clean water.
360° CONNECTOR BASE
The 360° connector between the kettle and its base
means that the kettle can be located at any point on the
base. This is ideal for left and right-handed users as the
kettle can be positioned conveniently on your kitchen
counter.
TECHNICAL DATA:
220-240V • 50/60Hz • 1850-2200W
Environment friendly disposal
You can help protect the environment! Please
remember to respect the local regulations:
hand in the non-working electrical equipments to an
appropriate waste disposal center.
3
Publicité
