Charging Procedure; Important Charging Notes - Black & Decker BDCS20 Manuel D'instructions

fuNcTIoNAl
deScRIPTIoN
1) SWITCH
2) FORWARD / REVERSE /
LOCk OFF SLIDER
3) HEx SPINDLE
4) CHARGING PORT
5) CHARGING PLUG
6) CHARGER

charging Procedure

cHARGING PRoceduRe - fIGuRe B
IMPoRTANT: The batteries in your tool
are not fully charged at the factory. Before
attempting to charge them, thoroughly read all
of the safety instructions.
(1) The charging port (4) is keyed to lock out
other chargers. Align the tab in the charger
plug (5) with the key in the charging socket.
(2) Plug the charger output plug (5) into the
charging port (4) of the tool as shown in
figure B.
(3) Plug the charger (6) into any standard 120
Volt 60 Hz electrical outlet.
(4) Let the tool charge initially for at least 16
hours. After the initial charge, your tool should
be fully charged in 16 hours from a fully
discharged condition. Recharge discharged batteries as soon as possible after use
or battery life may be greatly diminished. for longest battery life, do not discharge
batteries fully. It is recommended that the batteries be recharged after each use.
WARNING: Do not use tool while it is connected to the charger.
WARNING: Fire Hazard. When disconnecting the charger from the tool, be sure to
unplug the charger from the outlet first, then disconnect the charger cord from the tool.

Important charging Notes

1. Your tool was sent from the factory in an uncharged condition. Before attempting to
use it, it must be charged for at least 16 hours.
2. CAUTION: To reduce the risk of damage to the batteries, NEVER charge them in
an air temperature below 40°F (4,5°C) or above 105°F (40,5°C). Also, NEVER
charge them if the battery temperature is below 40°F (4,5°C) or above 105°F
(40,5°C). Longest life and best performance occurs when batteries are charged with
A
3
5
B
6
2
1
6
4
4
5