Publicité
Les langues disponibles
Les langues disponibles
Assembling the speaker stands and securing your front
and surround (S-FCR4700 only) speakers
Attach the speaker stand bases to the stems using the screws
provided.
Once you have aligned the stem and base, secure with the
small screws at the points shown below. Note that the speaker
should face in the direction of the base of the isosceles triangle
(outlined below).
Rear
Front
Secure each of the front and surround (S-FCR4700 only)
speakers using the metal catch provided.
Screw two picture hooks or similar into the wall behind the
speaker. Pass a chain or cord around the hooks and through
the metal catch so that the speaker is stabilized (make sure to
test that it supports the weight of the speaker).
After installing, make sure the speaker is securely fixed.
CAUTION:
• The metal catch is not a mounting fixture, and the speaker
should not be hung directly from the wall using this catch.
Always use a chain or cord when stabilizing the speaker.
• Pioneer disclaims all responsibility for any losses or
damage resulting from improper assembly, installation,
insufficient strength of the installation materials, misuse, or
natural disasters.
NON-SKID PADS
Attach the small non-skid pads to the base of the surround (S-
FCR3700 only) and center speakers. The large non-skid pads
are for the front and surround (S-FCR4700 only) speakers, and
the subwoofer (as shown).
Use the adhesive side of the pads to attach them to the base of
each speaker and the subwoofer.
If you choose to use speaker stands with the surround speakers,
attach the non-skid pads to the stand bases instead of to the
underside of the speakers (S-FCR3700 only).
Chain or cord
Metal catch
Small non-skid pads
Center speaker
Surround speakers
(S-FCR3700 only)
Large non-skid pads
Front and Surround
(S-FCR4700 only) speakers
Optionally, attach the surround speakers to
the speaker stands (S-FCR3700 only) .
For each speaker,line up the spurs on the stand with the holes
on the back of the speaker and insert, then secure the speaker
to the stand with the screw provided.
WALL MOUNTING THE SURROUND
(S-FCR3700 ONLY) AND CENTER SPEAKERS
The surround (S-FCR3700 only) and center speakers have
mounting holes which can be used to mount the speaker on the
wall.
5 mm to 7 mm
Before mounting (see above), keep in mind the following points:
¶ Remember that the speaker system is heavy and that its
weight could cause the screws to work loose, or the wall
material to fail to support it, resulting in the speaker falling.
Make sure that the wall you intend to mount the speakers on
is strong enough to support them. Do not mount on plywood
or soft surface walls.
¶ Mounting screws are not supplied. Use screws suitable for
the wall material and support the weight of the speaker.
CAUTION:
• If you are unsure of the qualities and strength of the walls,
consult a professional for advice.
• Pioneer is not responsible for any accidents or damage
that result from improper installation.
www.pioneerelectronics.com
speaker stand
(S-FCR3700 only)
Subwoofe
5 mm
10 mm
3
Publicité
