Replacing The Batteries - Alecto SA20 Mode D'emploi

duce and regularly practice use of the escape route.
• Leave the house immediately according to the plan when hearing the
alarm. Every second counts: so respond quickly. If you do not notice
smoke or heat, check if everyone in the house is in a secure location.
• Do not open any doors without feeling wether the door is warm or if there
is smoke coming from underneath the doors. If it is, do not open that
door. If the door is cold, put your shoulder firmly against the door and
open it a small amount to check for any heat or smoke first.
• If there is much smoke, keep low and take shallow breaths, preferably
through a moist towel. Call the fire department as soon as you are safe
outside.

REPLACING THE BATTERIES:

The detector is supplied using a 9Volt blok battery. Only use the recommen-
ded type Gold Peak 1604A or Duracell MN1604. Under normal conditions
the battery will last at least one year. If it is about to need replacement, the
smoke detector will make a chirping sound every 30 to 40 seconds for at
least 30 days. Pay attention to the polarity when replacing batteries. Test
the detector after every battery replacement. If the smoke detector does not
function, please contact your supplier.
ENVIRONMENT:
Do not throw away used batteries, but recycle them using your
local chemical depot. Product may not be thrown out as normal
waste, but must be recycled as electrical waste.
DECLARATION OF Performance:
Is available at the following internet address:
http://DOC.hesdo.com/SA20_DOP_1.pdf