Replacing The Brush; Disposal Of Batteries - Bissell POWERGLIDE Cordless 1538 Série Mode D'emploi

Maintenance & Care
Cleaning the Filter and Cyclone
1. Release tank and remove lid as above,
then remove Pre-motor Filter, clean with mild
detergent and rinse.
2. Reinsert inside Dirt Container, once
completely dried.
3. Remove cyclone system from dirt container
as above.
4. The cyclone system can be broken down
into three parts for easy cleaning. All pieces
come apart with a simple twist. Rinse and dry
with a paper towel.
Tip
» To maintain suction and good performance, it is
recommended that you clean your filters every
4-5 uses and clean your cyclone system every
other time you clean the filter.

Replacing the Brush

1. Turn power switch off, turn over and use a
coin or a flathead screwdriver to open the 2
locking screws on either side of the brush bar.
2. Remove both brush plates to access
brush bar.
3. Grasp the roller from the bottom, dislodge
by pulling, and then thread it through the belt.
4. Replace roller and reverse the order to
reassemble.

Disposal of Batteries

If your vacuum is to be disposed of, the batteries
should be removed and disposed of properly.
1. Keep Battery Pack together – DO NOT
disassemble the battery pack. For specific
disposal instructions of batteries, please follow
local regulation.
www.BISSELL.com
8
1.
3. 4.
1.
3.
2.
2.
4.