Installing Rear Ballast; Maintenance - Cleaning - Lubrication; Engine; Filling With Oil - GOLDONI UNO Série Emploi Et Entretien

4.9 INSTALLING REAR BALLAST

(Optional)
Model 8DS, when ballast is required, needs the drawbar to attach it.
Installation can be in two different ways (see fig.4) depending on the attachment:
Cultivator 19: drawbar lowered to position 1 and ballast raised to position A.
Or: drawbar raised to position 2 and ballast lowered to position B.
Drive 85: drawbar raised to position 2 and ballast lowered to
position B.
Drive 70: drawbar lowered to position 1 and ballast lowered to position B.
Type of attachment
Cultivator 19
Or:
Drive 85
Drive 70

5. MAINTENANCE - CLEANING - LUBRICATION

5.1 ENGINE

Refer to engine operating manual.

5.2 FILLING WITH OIL

5.2.1 Gear box

Check level via plug B fig.9
It is advisable to use AGIP BLASIA S-220 oil.
Change the oil every 300 hours or after two years. Amount required: 2 kg
approx.
Add the oil through plug B fig.9.
To drain oil: plug A fig.10.

5.3 REGISTRATIONS AND CHECK UPS

5.3.1 Registering the clutch

Check the clutch lever from time to time. If there is too much play, adjust with
register E fig.5.
Ballast installation
Position Drawbar
Low (1)
High (2)
High (2)
Low (1)
39
Position Ballast
High (A)
Low (B)
Low (B)
Low (B)