GMC MRHD1500 Mode D'emploi page 5

c. Disconnect the plug from the power source and/or the
battery pack from the power tool before making any
adjustments, changing accessories, or storing power
tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
d. Store idle power tools out of the reach of children and do
not allow persons unfamiliar with the power tool or these
instructions to operate the power tool. Power tools are
dangerous in the hands of untrained users.
e. Maintain power tools. Check for misalignment or binding
of moving parts, breakage of parts and any other
condition that may affect the power tool's operation. If
damaged, have the power tool repaired before use. Many
accidents are caused by poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly maintained
cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc. in
accordance with these instructions, taking into account
the working conditions and the work to be performed.
Use of the power tool for operations different from those
intended could result in a hazardous situation.
5. SERVICE
a. Have your power tool se rviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
Additional Safety for Hammer Drills
• For safety relating to protective clothing/equipment and
general health hazards relating to power tools; refer to
General and Electrical Safety sections in this manual
• Important: It is imperative to follow all national safety
regulations concerning installation, operation and
maintenance
• Do not allow anyone under the age of 18 years to use this
tool, and ensure that operators are qualified and familiar
with the operating and safety instructions
• When using the drill, use safety equipment including safety
glasses or shield, ear defenders, and protective clothing
including safety gloves. Wear a dust mask if the drilling
operation creates dust
• Use metal and voltage detectors to locate concealed
electric, water or gas lines. Avoid touching live components
or conductors
• Extension cable reels used with this tool must be
completely unwound. Minimum conductor cross section:
1.0mm2
• When using this tool outdoors, connect to a power supply
with an RCD device and minimum 1.5mm2 extension cable
with water protected plugs in good working order
• Ensure that the chisel or drill bit is securely fixed in the
chuck. Insecure drill bits can be ejected from the machine
causing a hazard
• Ensure that the lighting is adequate
• Ensure that the drill bit is in contact with the workpiece prior
to starting up the tool
• Before drilling, check that there is sufficient clearance for
the drill bit under the workpiece
• Use both hands when operating this tool
• Use auxiliary handles supplied with the tool
• Do not put pressure on the tool, to do so would shorten its
service life
• Drill bits get hot during operation, allow to cool prior to
handling them
• Never use your hands to remove sawdust, chips or waste
close by the bit
• If you are interrupted when operating the drill, complete the
process and switch off before looking up
• Where possible, use clamps or a vice to hold your work
• Always disconnect the hammer drill from the electric supply
before changing a chisel or drill bit
• Examine the chuck regularly for signs of wear or damage.
Have damaged parts repaired by a qualified service centre
• Always wait until the drill has come to a complete stop
before putting it down
• On completion of the work, disconnect the tool from the
power source and remove chisel/bit from the machine
• Periodically check all nuts, bolts and other fixings and
tighten where necessary
5
GB