_D10_D10-LX.book Seite 13 Montag, 22. November 2010 5:27 17
D10 / D10-LX
Charging the charge box with D10-LX wine cooler
To charge the charge box with the D10-LX use the provided mains adapter
and connect it to a 100-240 V mains socket.
➤ Set the function switch (2 2, page 3) to "CHARGE".
➤ Insert the round plug on the mains adapter into the power connection
(3 1, page 3) on the device.
➤ Plug the mains adapter into a 100-240 V outlet.
✓ The red charge display (2 1, page 3) lights up.
✓ The charge box is charged. The charging time is approximately eight
hours.
If the charge display flashes red, either the charge box is not correctly aligned
or there is a malfunction.
After charging
✓ If the charge-display light is green, the charge box is charged.
➤ Set the function switch to "OFF".
✓ The charge display turns off.
6.6
Decommissioning the device
➤ To decommission the device, switch the function switch to "OFF" and, if
necessary, pull the connection cable from the socket.
➤ If you will not be using the device for a long time, remove the battery box/
charge box from the device by grasping it on the bottom of the device and
pulling it towards the front (see 3, page 4).
The charge box then loses its charge in the course of time. If you are not
using the device, you should still recharge the charge box approximately
every three months.
Operation
13