Instructions - Walter E-WELD PLASMA 53-L 126 Instructions D'utilisation Et De Maintenance

E-WELD PLASMA SPAYER 53-L 126
• When working with the sprayer, wear the necessary protective
clothing, safety goggles, work gloves, ear protection and if neces-
sary and a respirator mask.
• The disposal of the compressed air tool must be carried out in ac-
cordance with the valid legal regulations.
• If leaks occur on the device or other operating faults, the device
must be disconnected from the compressed air supply immedia-
tely and the cause of the fault remedied.
• Processed liquids and cleaning agents must be disposed of in an
environmentally friendly manner.

6. Instructions

Screw in the appropriate compressed air connection and tighten firmly using a
13 mm open-end or open-end wrench. If necessary, glue it in place.
Screw the pressure gauge included witht he product into the pressure regula-
ting unit, glue it in, if necessary.
Unscrew the pressure tank and fill the liquid into the tank.
Alternatively: When using a 1-liter can pierce the protective film and immerse
the riser in the liquid.
Then screw the 1-liter can into the threaded receptacle of the sprayer by hand.
Make sure that the can is properly screwed to the sprayer!
Then hand-tighten the sprayer with the container lid onto the pressure vessel.
Do not use tools for this! Connect the sprayer to the compressed air system via
the quick coupling. Actuate the trigger lever to operate the sprayer.
PAGE | 4
V1.00/ DEC18